How to Make a Braided Fall Wreath, Easy to Sew

This easy to sew fall wreath is a great way to use up your fabric scraps. This would  also make a great beginner sewing project. 

Fall Braided Wreath|Designers Sweet Spot|

The first time I made a wreath like this was in the Girl Scouts in 5th grade. It’s crazy how some things stick with you over the years. At the time, I was new to sewing and this was my very first sewing project. I’ve been hooked on sewing ever since.

The wreath is made from 3 “sleeves” of cotton batik quilting fabric in beautiful fall colors. It would be easy to make different colored wreaths for different seasons, but I must say I love these rich warm colors. The sleeves are braided together and attached to a grapevine wreath with some twine for a rustic farmhouse feel.

This little door is in our entry way. It leads to no where but a closet. This is a small storage area under our stairs that we use for off season items like Christmas decorations and winter shoes and boots. I love the little quirky parts of an old house like this!

Here’s what you will need to make your own wreath:

Fall Wreath Supplies Needed:

This post contains affiliate links. By making a purchase I will receive a small commission at no extra charge to you. For a complete list of rules, see the disclosures page.

1/4 yard cuts of three fall colored batik fabrics (yellow, brown, green)

•Sewing machine and thread

•sewing needle

polyester fiberfill stuffing

•plastic 12″ ruler

•large safety pins

•Scissors or rotary cutter and mat

12″ grapevine wreath


•faux eucalyptus branches

•gold ribbon

Fall Farmhouse Wreath |Designers Sweet Spot|

Fall Wreath Directions:

  1. Cut 5″ wide strip from each one of the fabrics the length of the goods (in this case it was 44″ wide).
  2. Fold the strips right sides together, in a lengthwise direction. Sew across the short end and down the long edge with a 1/4″ seam allowance.
  3. Repeat for each colored strip.
  4. Turn the fabric sleeves, right side out. Press.
  5. Stuff the tubes with fiberfill stuffing. Use the plastic ruler to push the stuffing into the bottom of the tube, and fill it 1″ from the top edge. Pin the raw edges together temporarily with a safety pin.
  6. Pin the top of the stitched tubes together with a safety pin. Whip stitch them together with a needle and thread. Remove safety pins, leaving bottom edges free.
  7. Conceal the stitches by folding one of the tubes over the stitching. Then proceed to braid the three tubes together as shown in photograph. Form into a wreath shape, pin bottom edge together with top of wreath. Whip stitch in place to form the wreath shape with needle and thread. You may need to twist some of the tubes a bit to hide any seams that may show towards the back of the wreath.
  8. Flatten the wreath against the 12″ grapevine wreath. Weave twine in and out, around the wreaths to hold them together. Add bits of eucalyptus and a gold ribbon bow if desired. Hang with another piece of twine.

If you enjoyed this post, don’t forget to Pin it!

Fall Braided Wreath|Designers Sweet Spot|

More great ideas are in store for you in the posts below:

Sewing with Lace

Sewing a Fleece Robe

Make A Stunning Shibori Print Shoulder Bag

How to Make a Dresden Plate Pillow

Yo-Yo Wine Bottle Bag

Join the Sewing Community

Subscribe to get FREE Learn to Sew Worksheets.

Powered by ConvertKit

Don’t miss out!


Leave a Reply

Your email address will not be published. Required fields are marked *